FMEA (Failure Modes and Effects Analysis)#

filesystem FMEA
status: draft
safety: ASIL_B
realizes: wp__sw_component_fmea
doc__filesystem_fmea
Generic Document

Note

Use the content of the document to describe e.g. why a fault model is not applicable for the diagram.

Failure Mode List#

.. comp_saf_fmea:: <Title>
   :violates: <Component architecture>
   :id: comp_saf_fmea__<Component>__<Element descriptor>
   :fault_id: <ID from fault model :need:`gd_guidl__fault_models`>
   :failure_effect: "description of failure effect of the fault model on the element"
   :mitigated_by: <ID from Component Requirement | ID from AoU Component Requirement>
   :mitigation_issue: <ID from Issue Tracker>
   :sufficient: <yes|no>
   :status: <valid|invalid>

Note

argument is inside the ‘content’. Therefore content is mandatory

Attention

The above directive must be updated according to your component FMEA.

  • The above “code-block” directive must be updated

  • Fill in all the needed information in the <brackets>